Senertek 3D Cast V3 Printing Resin

• Enlighten AA temp – Dental resin material
• Designed for FDA and TFDA approved temporary crowns.
• Quantity 1000 Gms and 500 Gms
• Suitable for temporary crowns.
  
  

1.Very high heat resistance 238 degrees (many of the materials below 100 degrees and less suitable)
2.Very high bending strength compared to competitors
3.Significantly better resolution than other crown materials
4.RX – you can take a photo and check the quality of the fit
5.Raw material is less thick, allows for faster printing and prevents unnecessary gifts for entering material during execution (in order to prevent air bubbles)
6.Does not break in an intact jaw unlike other materials
7.No special equipment that requires gas is required, possible with any normal UV (better with heating or use hot water before the cure)